Hardware Setup Guide for Toshiba ST-B10

[G.W.Green]

This guide is designed to take you through setting up the Toshiba ST-B10 EPOS hardware that you will be using with your SellerDeck EPOS software.

You should have the items shown in the following picture:





Please see instructions below:

1. Plug the Blue Deskey dongle into any USB port on the back of the STB-10 unit:
   
   
   
   
2. At this point you can also plug in the scanner into any USB port.
3. Plug the cable from the pole display into the port marked “Com 4” on the back of the STB-10 unit.
   
   
   
   
4. Now to the back of your receipt printer, first plug in the power cable.
5. Next, cable the small connector from the back of the cash drawer, and plug it into the back of the receipt printer. (See below)
6. Next, plug the small end of the serial cable you have into the back of the receipt printer.
   
   
   
   
7. Next, plug the larger 25 pin end of the serial cable, into the port marked “COM 1” on the back of the STB-10 system.
   
   
   
   
8. Plug the power cable from the receipt printer, into the port marked “USB / 24V” on the back of the STB-10 system. (See below)
9. Finally, plug the cable from the touch screen, into the port marked “LVDS” on the back of the STB-10 unit.
   
   

The system should now be ready to work out of the box, but if you find it doesn't, see instructions to configure the hardware here:
http://community.sellerdeck.com/showthread.php?t=50458