Eft

[mark.adams]

I am trialling the demo of actinic epos, which so far seems to be just what i have been looking for although i have a couple of questions.
Is it possible to add any other devices like a bracode printer for instance rather than a laser printer for the barcodes.
Also i would like to check out the EFT part of the system, i already have an epos enabled keyboard and dionne extreme pinpad but i can't seem to find where to obtain the yeseft program.
Are there demo merchant account details to test this with also?

Thanks

Mark

[James M SellerDeck]

Hi Mark

There is a test vendor account you can use to trial the yespay interface with your chip and pin pad.

If you email the link at the bottom of this page, then I can send you the nessecery files, which includes the setup file, plus the instruction manual on how to set up the chip and pin pad, it also gives you a trial terminal id and merchant id number to use.

If you run the file EasyVterminal-version-2.1.1.msi, then run through the configeration in the setup guide.

Hope that helps