Unable to move to the cgi-bin directory "/cgi-bin/" on the FTP server.

[Duncan Rounding]

I think you're almost there.

I'm not too sure about windows servers - other may know better - but I believe you may have to get the permissions set by your host.

[Mike Hughes]

I guessed we were looking at a windows server. This may need to be done by your host, but the details of what needs doing should be at the end of this thread:

http://community.actinic.com/showthread.php?t=28725

Mike

[mst05]

I guessed we were looking at a windows server. This may need to be done by your host, but the details of what needs doing should be at the end of this thread:

http://community.actinic.com/showthread.php?t=28725

Mike

Thank you everyone for being so helpful.

I have read a document titled AdvanceGuide_8_v14.doc for Actinic. I've followed Section G which discusses the procedures in dealing with windows server. Unfortunately, it still says that I don't have a write permission.

In addition, I tried to assigned "Everyone" to full control so as to check if it's really the permission problem. It still says that I still have a write permission problem. I don't know what else to do. It seems that this shouldn't be running in windows server. What do you think?

[Duncan Rounding]

Actinic will run on Windows servers but unfortunately it seems it is usually harder to set up and very few people have a full working knowledge of doing so. Have you tried contacting supprt?

[mst05]

Actinic will run on Windows servers but unfortunately it seems it is usually harder to set up and very few people have a full working knowledge of doing so. Have you tried contacting supprt?

Thank you for your advice. I have re-submitted this problem to their support just now.